Chinese plastic injection molding and MASTER plastic rattan garden furniture application

China plastic injection molding and MASTER plastic rattan garden furniture: runner and gate at the parting line, and products in the mold with demolding, the most simple design, easy processing, low cost,MASTER plastic rattan garden furniture so more people to use flood system operation. Plastic mold structure is divided into two parts: the fixed die and the moving die. With the active injection machine part is movable mould, injection molding machine injection in the end do not generally called the fixed mould. Because the fixed mould part of large nozzle mold generally formed by two pieces of steel is also known as "the structure of the mold two plate mold". Two plate mold structure is the most simple edge gate.

中国塑料注射成型：流道及浇口不在分模线上，一般直接在产品上，中国塑料注射成型所以要设计多一组水口分模线，设计较为复杂，加工较困难，一般要视产品要求而选用细水口统。细水口模具的定模部分一般由三块钢板组成故也有称此类结构模具为“三板模”。三板模是细水口模具中最简单的结构。

MASTER china plastic injection molding: runner and gate is not in the parting line, directly on the product,MASTER china plastic injection molding so to design a set of nozzle parting line, MASTER plastic rattan garden furniture design is more complex, processing more difficult, usually depending on the product requirements and selection of fine nozzle system. The fixed mould part small inlet die is formed by three pieces of steel is also known as "the structure of the die mould". Three plate mold structure is small inlet die the most simple.

或多个有恒温的热流道板及热唧嘴里，无冷料脱模，流道及浇口直接在产品上，所以流道不需要脱模，此系统又称为无水口系统，可节省原材料，适用于原材料较贵、制品要求较高的情况，设计及加工困难，模具成本高。（中国塑料注射成型）热流道系统，又称热浇道系统，中国塑料注射成型主要由热浇口套，热浇道板，温控电箱构成。我们常见的热流道系统有单点热浇口和多点热浇口二种形式。

Or a constant temperature hot runner plate and heat pump mouth, no cold material release, runner and gate on the products directly,MASTER plastic rattan garden furniture so the channel does not need to release, this system is also known as the no water inlet system, which can save raw materials, suitable for raw materials, products more expensive higher requirements, design and processing difficulties high cost,MASTER plastic rattan garden furniture mould.China plastic injection molding hot runner system, also known as hot runner system, China plastic injection molding is mainly composed of a hot runner sleeve, hot runner plate, temperature control electric box. Our common hot runner system has a single point and multi-point hot runner hot runner in two forms.